

Jan K.
Steering lock issue | MERCEDES-BENZ
Hello, maybe someone has a tip for me where I can start?! :-) The key won't turn and the steering lock won't disengage. Thanks in advance!
Already checked
The user is having trouble with their car's steering lock. The key won't turn and the steering lock is not disengaging.
MERCEDES-BENZ
Own solution
Comments (3)
Christian G. It seems to have an electronic lock that is causing problems, like the electric steering wheel lock. Can both be sent in for testing and repair, e.g. to Ecu.de?
OpenRoland L. This is due to the lock; the electronics of the key can probably no longer communicate with the electric steering lock. This is a fairly common problem. As far as I know, a new ignition lock needs to be installed.
Related posts for this car MERCEDES-BENZ
Problem with rough running on gasoline | MERCEDES-BENZ
Hello, I have a problem. The vehicle runs roughly like a tractor when running on gasoline. There is no entry in the fault memory. After switching to natural gas operation, the car runs perfectly. The high-pressure gasoline pump was checked using Stardiagnose, and all values are within the target range. Thanks for your help
Karsten O. · 07/19/21
OpenCar won't start | MERCEDES-BENZ
Good evening everyone, Unfortunately, my car won't start anymore. We wanted to start it the next morning and lo and behold, nothing works. The key and the ignition switch can be turned all the way. Contact and ignition work, but when I try to start it, nothing happens. The car was at a trusted workshop, but they couldn't find the problem. The same happened at the Mercedes-Benz partner, who also made no progress with their troubleshooting. Thanks
Fabian S. · 07/21/21
OpenEngine light and camshaft sensor | MERCEDES-BENZ
Hi, my engine light keeps turning on and off by itself. Error code P0366 Camshaft Position Sensor B. Anyone have any idea? Thanks
Christian S. · 07/21/21MB W204 220 CDI 179PS - Multiple System Failures and Poor Acceleration | MERCEDES-BENZ
First the ASR malfunction message appeared, followed by the tire pressure monitoring system malfunction message. Then the engine control light came on. Poor throttle response. Normal acceleration from approx. 2000 rpm. Kick-down does not work... OBD readout unsuccessful... I am grateful for any tip.
Roland P. · 07/19/21Grinding noise when steering right on S204 | MERCEDES-BENZ
I have a grinding noise when steering right on an S204. It sounds almost as if the heat shield is rubbing against the brake disc, which is not the case. What could it be? I suspect the brake caliper.
Enver P. · 07/19/21Related posts about these topics Engine
Whistling noise under load in Astra | VAUXHALL
I have the problem that my Astra starts to make a whistling noise under load from about 100 / 110km/h. The whole thing can only be heard when I accelerate with the pedal or the cruise control is switched on. As soon as I let the car roll, the noise disappears. There are no error codes stored. Noise gets louder with increasing speed. Engine code: z18xe
Marius92 · 07/19/21Peugeot 3008 1.6 THP 156hp - Radiator fan constantly running at high speed | PEUGEOT
Hello, I have the following problem with a Peugeot 3008 1.6 THP 156hp. The radiator fan is constantly running at high speed, even when the car is cold.
Lutterschmid C. · 07/19/21Recurring Display Message and Glow Plug Issues | VAUXHALL
I keep getting this message on the display. I clear it with OBD2, but it returns after two days. I went to an Opel garage, and they cleared it, saying it was a "glow plug problem". Could that be the cause?
Rabit Z. · 07/19/21Excessive pressure in the system after engine overhaul | VAUXHALL
Hello everyone! I have the following problem: too much pressure is building up in the system, and replacing the turbocharger with water is not working properly either. The engine has been completely overhauled! Where would you start? Thanks for the answers.
Andre K. · 07/20/21Engine knocking in Ford Transit 2.0 TDCI | FORD
Hello everyone, I have the following problem with a 2003 Ford Transit 2.0 TDCI 92KW with 278000km mileage. Under load from approx. 2500 rpm, the engine starts to knock (metallic clattering). When starting off when cold, you can also hear a knocking.
Andi R. · 07/22/21

One more thing occurred to me, and that led me to the solution! I cleaned the EIS or the lens with soapy water and a cotton swab, and it works perfectly again 👍 There was a pretty thick layer of dirt on it. And the night is over now.