

Gunnar C.
Dashboard display failure in cold weather | RENAULT
Hello everyone,
In winter, I have the problem that my speedometer display goes out completely and then comes back on, or it remains completely dead. When I press the dead man's switch, everything works again. Can anyone help me with what this could be? When the days are warmer, I don't have this problem.
RENAULT
1.6 16V (JA0B, JA04, JA11, JA00)
Automatikgetriebe
Own solution
Comments (2)
Rene Your speedometer is defective, but it can be repaired. Also fits your description that it mainly occurs in the cold. You can read it carefully.
👏9
Related posts for this car RENAULT
Air conditioning system fails shortly after filling | RENAULT
Last year, the following parts were replaced by a friendly specialist workshop, also due to troubleshooting: - AC compressor - AC condenser - AC dryer - Evaporator temperature sensor After replacing the sensor, the system ran for 3 days. Yesterday, according to the workshop, 1000g of refrigerant was extracted and refilled with 1050g. The system worked until noon today. Now no effect again. I have great confidence in the workshop. But somehow they are currently in a dead end. Does anyone have a useful suggestion? Thanks
Frank A. · 07/21/21
OpenUPC Replacement | RENAULT
Hi, I have a question. When I bought the car, the windshield wipers only worked in the second and third stages. But they didn't stop in the home position, i.e. at "3 o'clock", but randomly. Sometimes at 12 o'clock or even at quarter past two. Now they don't work at all. The workshop checked all the cables and the wiper motor. They say that the UPC is defective. My question is whether a new UPC control unit should be bought and whether a used one can serve its purpose.
Alexander M. · 07/21/21
OpenESP/ABS errors after replacement of ABS control unit | RENAULT
Hello, According to readouts with Renolink and Delphi, the above-mentioned error messages are displayed. "ESP def. error code 50c3 or DF017 ABS control unit def." I have already checked some things and also replaced the ABS control unit + taught it in. But the same error messages are still there. When turning a little faster, the ESP was triggered and shortly afterwards the ESP/ABS was def. Anyone have any ideas? Thanks
Sven H. · 07/21/21Related posts about these topics Electrics
Problem with rough running on gasoline | MERCEDES-BENZ
Hello, I have a problem. The vehicle runs roughly like a tractor when running on gasoline. There is no entry in the fault memory. After switching to natural gas operation, the car runs perfectly. The high-pressure gasoline pump was checked using Stardiagnose, and all values are within the target range. Thanks for your help
Karsten O. · 07/19/21Parasitic drain | BMW
Hello, I have had a parasitic drain for a while now. When the vehicle is parked, a 100 Ah battery lasts about 2 days, then it is empty and nothing works without jump starting. How do I check this?
Zoran G. · 07/22/21UPC Replacement | RENAULT
Hi, I have a question. When I bought the car, the windshield wipers only worked in the second and third stages. But they didn't stop in the home position, i.e. at "3 o'clock", but randomly. Sometimes at 12 o'clock or even at quarter past two. Now they don't work at all. The workshop checked all the cables and the wiper motor. They say that the UPC is defective. My question is whether a new UPC control unit should be bought and whether a used one can serve its purpose.
Alexander M. · 07/21/21Starting problems when warm | AUDI
Hello, I hope someone can help me. The problem is the following: As soon as it is above approx. 23 degrees Celsius outside and the car is driven and then stands for longer than 15 minutes, it hardly starts the next time, unless you accelerate, then it starts sometime. But then it runs completely normally. If it is cooler outside, the problem does not occur, no matter how long you drive or stand. The following has already been replaced/checked: Fuel pressure regulator, fuel pressure, fuel pump, crankshaft sensor, camshaft sensors, temperature sensor, fuel tank vent valve. Hope for help! Thank you! Engine code: AQJ Transmission code: EFN Fault memory empty
Roland L. · 07/19/21DTC intervention on BMW E87 120d | BMW
Hello everyone, I have a problem with a BMW E87 120d with about 210,000km, model year 2010. The DTC intervenes spontaneously again and again without it needing to or being necessary. Sometimes it brakes the vehicle very hard, then you have to switch off the DTC so that you can drive normally again. Meanwhile, it also intervenes when the DTC is switched off. It occurs regardless of whether driving straight or cornering. Fault memory in the engine, transmission, chassis and DTC/DSC/ABS is empty… I have also already done a parameter run for the wheel speed sensors and there is nothing conspicuous. Wheel bearings are also OK after visual inspection. Drive shafts too. Does anyone have an idea? Thanks a lot and greetings Patrick
Patrick N. · 07/20/21

Car sold